This is a working overview of Ac-LKKTETQ, written for readers who want more than a one-paragraph summary but less than a textbook.
Reviewed 2026-08-01. Anything still debated is marked as such rather than presented as settled.
Once in solution, short peptides are generally less stable than the dry powder, and repeated freeze-thaw cycles are a common cause of loss. Laboratory guidance usually calls for aliquoting on first dissolution and storing aliquots at -20 °C or below, away from light. Adsorption to plastic and glass surfaces can lower measured concentration, particularly at low concentrations, so container material and buffer choice can affect results. Visible cloudiness, colour change or unexpected precipitate is a signal to re-check the material.
Purity is normally assessed by reversed-phase HPLC, with the main peak reported as a percentage of total peak area, while identity is confirmed by mass spectrometry. Electrospray and MALDI-TOF instruments are both used, and the observed mass is compared with the value calculated from the stated sequence. Ion-exchange or size-exclusion methods appear where aggregation or charge variants are of interest. Water content, counter-ion content and residual trifluoroacetate from purification are separate variables that can shift the measured mass and should be weighed when reading a certificate of analysis.
Research peptides are typically supplied as a white to off-white lyophilised powder in a sealed vial. The dry solid is more stable than a solution and is normally kept refrigerated or frozen until use. Dissolution is usually done in water, phosphate-buffered saline or a similar aqueous medium, depending on the assay. Because the material is hygroscopic and easily contaminated, opening vials in a low-humidity environment and recording the lot number before use are standard laboratory practices.
TB-500 is a synthetic peptide preparation marketed under a name derived from thymosin beta-4, a 43-residue actin-binding protein first isolated from thymus tissue. The full-length protein has a reported molecular mass near 4963 Da, while material sold as TB-500 is often described as a fragment containing the actin-binding motif LKKTETQ. Because suppliers use the name inconsistently, published sources sometimes refer to the same label as a fragment, a synthetic copy, or a related analog. This naming ambiguity complicates direct comparison of reports across studies.
Laboratory work on thymosin beta-4 describes binding to monomeric actin and effects on cell migration, angiogenesis, and inflammatory signaling in cultured cells. Animal models have examined skin, corneal, and cardiac repair after injury, with outcomes reported mainly in preclinical literature. Most of that evidence concerns the parent protein rather than preparations labelled TB-500, so extrapolation from animal findings to a specific commercial product remains uncertain. Whether the two behave identically in living systems has not been established in controlled human studies.
| Property | Value | Notes |
|---|---|---|
| Typical form | Lyophilised powder | Reconstituted before use |
| Storage temperature, dry | -20 °C or below | Desiccated, protected from light |
| Purity determination | Reversed-phase HPLC | Reported as percentage of total peak area |
| Identity confirmation | Mass spectrometry | ESI or MALDI-TOF versus calculated mass |
| Common synonyms | Tβ4 fragment; thymosin beta-4 fragment | Naming varies between suppliers |
TB-500 is a synthetic heptapeptide with the sequence Ac-LKKTETQ. It corresponds to a short N-terminal region of thymosin beta-4, a 43-amino-acid protein found in many cell types. The fragment contains an actin-binding motif, which is one reason it appears in laboratory studies of cell migration and cytoskeletal dynamics. TB-500 is not the full-length protein and is produced as a research chemical rather than an approved therapeutic agent. Its molecular weight is approximately 889 Da.
Several names appear in scientific and commercial contexts for this peptide. The label TB-500 is informal and does not follow standard biochemical nomenclature. Research articles more often describe the compound as a thymosin beta-4 fragment, Tβ4 fragment, or by its sequence Ac-LKKTETQ. Confusing TB-500 with full-length thymosin beta-4 can lead to incorrect assumptions about activity because the fragment lacks the remaining residues of the parent protein. The relationship between fragment and parent protein remains an active area of study.
Regulatory status differs by country, but TB-500 is not an approved pharmaceutical in major jurisdictions. It is commonly sold as a research chemical for laboratory use, which places responsibility for identity and purity on the supplier and the laboratory. Published human data are limited, and most reports involve preclinical models or cell culture. Questions about whether the fragment mimics all actions of thymosin beta-4, and under which conditions, remain open. Independent verification of any material is therefore a practical requirement in research settings.
The designation TB-500 circulates in laboratory and catalog contexts without a single agreed definition. Most product listings apply it to an N-terminally acetylated seven-residue fragment of thymosin beta-4, while other listings attach the same label to the full 43-residue protein. Because the term is commercial rather than systematic, two entries bearing identical names may describe different molecules. Any documentation should therefore state which sequence a given sample is claimed to contain.
The fragment most often associated with the name carries the sequence Ac-LKKTETQ, matching residues 17 through 23 of thymosin beta-4. That region holds the actin-binding motif responsible for much of the parent protein's biochemical activity. Apart from N-terminal acetylation the peptide is unmodified and contains no disulfide bonds, so it shows little ordered secondary structure in solution. Full-length thymosin beta-4 is instead a 43-residue polypeptide of roughly 4.9 kDa found widely across mammalian cell types.
Full-length thymosin beta-4 consists of roughly forty-three amino acids and ranks among the more abundant small proteins in the cytoplasm. The fragment is much shorter, so it cannot reproduce every function attributed to the intact molecule. In cell culture, short actin-binding motifs can interfere with filament dynamics and cell movement, but such observations come from controlled experiments rather than from whole-animal work. Whether a truncated fragment produces the same effects as the parent protein remains an open question.
Interest in the peptide grew during the 2000s and 2010s, when studies of tendon and ligament injuries in horses reported changes in lesion size after treatment. Those reports circulated widely outside the scientific literature and shaped much of the current online discussion. Subsequent reviews noted inconsistent study design, small groups, and a shortage of independent replication. Popular descriptions often blur the line between the fragment, the complete protein, and unrelated growth factors, which complicates comparisons across sources.
Reconstitution of a lyophilized peptide is normally done with sterile water or a suitable buffer under aseptic conditions. Adding solvent down the vial wall and allowing gentle dissolution instead of vigorous vortexing reduces the chance of aggregation, which can lower the effective concentration of the resulting solution. Concentrated stocks are usually diluted into working buffer shortly before use. Because no standard preparation protocol exists for TB-500 specifically, laboratories adapt general peptide handling practice, and reported results may reflect differing preparation choices.
Dry peptide powder is commonly kept at −20 °C in a desiccated container away from light, a practice that limits moisture uptake and oxidation. Once dissolved, solutions are generally held at 2–8 °C for short periods or frozen at −20 °C or lower for longer storage, with repeated freeze-thaw cycles avoided. Hydrolysis and oxidation are the main degradation routes for peptides in solution, and both accelerate at higher temperature or extreme pH. Published stability data specific to TB-500 are limited, so shelf life should be treated as uncertain.
Identity and purity checks for peptide material typically combine reversed-phase high-performance liquid chromatography with mass measurement, since retention time alone cannot confirm a sequence. Mass measurement verifies the expected molecular mass within instrument tolerance, while chromatographic peak area provides a purity estimate. Anti-doping analysis of urine uses related but more sensitive workflows, sometimes after solid-phase extraction. For research material, batch documentation, certificate content, and independent testing are common points of scrutiny, because supply chains outside pharmaceutical regulation vary widely in the paperwork they provide.
On 23 August 1990 — just over a month before German reunification on 3 October — East Germany reconstituted the five original Länder. Legally, it was these Länder that then acceded to the Federal Republic of Germany. In reality, the restored Länder did not fully reconstitute themselves until after reunification. On 14 October 1990, elections to the Landtage (state parliaments) were held in the five new states, initiating the formation of state governments. Since changes to the boundaries of municipal districts were not reversed, and also due to considerations of expediency, the territorial make-up of the restored Länder differed somewhat from the borders before 1952. Saxony and Saxony-Anhalt initially retained the rural and urban districts as administrative entities (Regierungsbezirke). Saxony-Anhalt later abolished them in 2003, while Saxony transformed them into directorates in 2008.
In Puerto Rico and the Dominican Republic, mofongo is made by mashing fried plantains in a mortar with chicharrón or bacon, garlic, olive oil and stock. Any meat, fish, shellfish, vegetables, spices, or herbs can also be added. The resulting mixture is formed into cylinders the size of about two fists and eaten warm, usually with chicken broth. Mofongo relleno is topped with creole sauce rather than served with chicken broth. Creole sauce may contain stewed beef, chicken or seafood; it is poured into a center crater, formed with the serving spoon, in the mofongo. Grated green bananas and yautias are also used to form masa, a common ingredient for dishes such as alcapurria, which is a type of savory fritter. Fufu de platano is a traditional and very popular lunch dish in Cuba, and essentially akin to the Puerto Rican mofongo. It is a fufu made by boiling the plantains in water and mashing with a fork. The fufu is then mixed with chicken stock and sofrito, a sauce made from lard, garlic, onions, pepper, tomato sauce, a touch of vinegar and cumin. The texture of Cuban fufu is similar to the mofongo consumed in Puerto Rico, but it is not formed into a ball or fried. Fufu is also a common centuries-old traditional dish made in Côte d'Ivoire, Ghana, Nigeria, Cameroon and other West & Central African countries. It is made in a similar fashion as the Cuban fufu, but is pounded, and has a thick paste, putty-like texture which is then formed into a ball. West African fufu is sometimes separately made with cassava, yams or made with plantains combined with cassava.
A ball check valve is a check valve in which the closing member, the movable part to block the flow, is a ball. In some ball check valves, the ball is spring-loaded to help keep it shut. For those designs without a spring, reverse flow is required to move the ball toward the seat and create a seal. The interior surface of the main seats of ball check valves are more or less conically tapered to guide the ball into the seat and form a positive seal when stopping reverse flow. Ball check valves are often very small, simple, and cheap. They are commonly used in liquid or gel minipump dispenser spigots, spray devices, some rubber bulbs for pumping air, etc., manual air pumps and some other pumps, and refillable dispensing syringes. Although the balls are most often made of metal, they can be made of other materials; in some specialized cases out of highly durable or inert materials, such as sapphire. High-performance liquid chromatography pumps and similar high pressure applications commonly use small inlet and outlet ball check valves with balls of (artificial) ruby and seats made of sapphire or both ball and seat of ruby, for both hardness and chemical resistance. After prolonged use, such check valves can eventually wear out or the seat can develop a crack, requiring replacement. Therefore, such valves are made to be replaceable, sometimes placed in a small plastic body tightly fitted inside a metal fitting which can withstand high pressure and which is screwed into the pump head.
Sources: en.wikipedia.org
The American black bear's generalist behavior allowed it to exploit a wider variety of foods and has been given as a reason why, of these three genera, it alone survived climate and vegetative changes through the last Ice Age while the other, more specialized North American predators became extinct. However, both Arctodus and Tremarctos had survived several other, previous ice ages. After these prehistoric ursids became extinct at the end of the Pleistocene, American black bears, brown bears and polar bears were the only remaining bears in North America.
=== Starch === Partially hydrolysed potato starch makes for another non-toxic medium for protein electrophoresis. The gels are slightly more opaque than acrylamide or agarose. Non-denatured proteins can be separated according to charge and size. They are visualised using Napthal Black or Amido Black staining. Typical starch gel concentrations are 5% to 10%.
=== Plasma cortisol concentration === Resting plasma cortisol may be slightly elevated in affected horses, but is commonly within normal limits or below normal. Additionally, elevations may occur secondary to stress, concurrent disease, and due to individual variation. Therefore, resting cortisol levels alone are not adequate to diagnose or rule out the presence of PPID.
Sources: en.wikipedia.org
Sealed, desiccated and protected from light, at -20 °C or lower for long-term storage. Short-term storage at refrigerator temperature is common in working laboratories.
Synthesis routes, purification steps and the analytical method used all affect the reported figure. A purity number is only comparable when the chromatographic conditions and detection wavelength are stated.
It reports what the supplier measured on a sample, which is useful but not absolute. Independent mass confirmation on the received lot is the more reliable check.
Not necessarily. TB-500 is a commercial label that suppliers apply to synthetic peptides described as thymosin beta-4 or a fragment of it. Published research most often studies the full-length protein, so statements about one do not automatically transfer to the other.