LKKTETQ raises a handful of sensible questions. This page answers them in order, starting with the fundamentals and moving to applications.
This page was last updated on 2026-01-28 and is reviewed periodically as new material appears.
Once dissolved, the peptide is far less stable than the dry powder. Aqueous solutions are subject to hydrolysis, oxidation at susceptible residues and gradual loss of material through adsorption onto glass and plastic surfaces. Terminal glutamine can cyclise under some conditions, producing a related species that complicates purity assessment. Dilute solutions tend to lose a larger fraction of material to surfaces than concentrated ones. Buffers, pH and ionic strength all influence the rate of change, so stability figures are only meaningful when those parameters are stated alongside the storage interval.
Detection in biological samples relies on mass spectrometry, typically liquid chromatography coupled to tandem mass spectrometry after peptide extraction and enrichment. Intact peptides can also be confirmed by high-resolution mass measurement together with fragmentation data. Detection windows in urine are short because the peptide is degraded by proteases and cleared quickly, and concentrations are low. Many jurisdictions treat the compound as a prohibited substance in sport, grouped with peptide hormones and related factors, while it is not an approved therapeutic product. Identity and purity statements therefore rest on certificates of analysis, ideally issued by an independent laboratory.
Material is normally supplied as a lyophilised powder in a sealed vial. The powder is hygroscopic, so exposure to humid air leads to water uptake, caking and gradual loss of the fluffy texture that indicates a good freeze-dry. Vials are best kept sealed with desiccant, protected from light and stored cold. Letting a cold vial warm to room temperature before opening reduces condensation on the contents. Purity is normally reported from a chromatographic run, and that figure applies to the batch as tested rather than to the vial after repeated opening.
TB-500 is a research peptide whose sequence matches residues 17 to 23 of thymosin beta-4, a 43-residue protein present in most mammalian cells. The chain is seven amino acids long, written as LKKTETQ, and is normally supplied with an acetyl group on the N-terminus. Suppliers list it as a lyophilised powder under the code name TB-500, and the same sequence appears elsewhere in catalogues as the thymosin beta-4 actin-binding fragment. The label is commercial rather than systematic, so no single authority fixes exactly what TB-500 denotes.
Thymosin beta-4 was isolated from calf thymus in the early 1980s and later characterised as an abundant intracellular actin-sequestering protein. Interest in short synthetic fragments grew once the actin-binding motif had been mapped to the middle of the sequence. TB-500 came out of that line of work as a truncated analogue rather than a natural isolate, and it is now sold mainly to laboratories. Published studies on the fragment have been largely in vitro or in animal models, and controlled human trials remain sparse, so claims about effects in people rest on extrapolation.
| Property | Value | Notes |
|---|---|---|
| Appearance | White to off-white solid | Lyophilised cake or powder |
| Solubility class | Freely soluble in water | Aqueous buffers also used |
| Typical storage temperature | About -20 degrees Celsius | Dry, sealed and protected from light |
| Typical analytical method | Reversed-phase HPLC or LC-MS/MS | Used for purity, identity and quantification |
| Common synonyms | Thymosin beta-4 fragment | Also listed under fragment-based descriptions |
The designation TB-500 circulates in laboratory and catalog contexts without a single agreed definition. Most product listings apply it to an N-terminally acetylated seven-residue fragment of thymosin beta-4, while other listings attach the same label to the full 43-residue protein. Because the term is commercial rather than systematic, two entries bearing identical names may describe different molecules. Any documentation should therefore state which sequence a given sample is claimed to contain.
The fragment most often associated with the name carries the sequence Ac-LKKTETQ, matching residues 17 through 23 of thymosin beta-4. That region holds the actin-binding motif responsible for much of the parent protein's biochemical activity. Apart from N-terminal acetylation the peptide is unmodified and contains no disulfide bonds, so it shows little ordered secondary structure in solution. Full-length thymosin beta-4 is instead a 43-residue polypeptide of roughly 4.9 kDa found widely across mammalian cell types.
Material sold under this label typically arrives as a freeze-dried powder in a sealed vial with a certificate of analysis. Such certificates usually report reversed-phase chromatography purity plus a mass confirmation, and stated purities commonly sit between 95 and 99 percent. Counter-ion identity, residual trifluoroacetate, water content, and peptide net weight are separate specifications that a certificate may or may not include. A purity figure alone does not establish sequence identity, so independent mass verification remains the practical check.
TB-500 is a short synthetic peptide sold under a trade name rather than a systematic chemical name. Suppliers usually describe it as a fragment of thymosin beta-4 and ship it as a lyophilised powder intended for laboratory use. Because the label is commercial, the exact sequence attributed to it is not fully consistent across catalogues, and some listings present a seven-residue peptide while others describe related fragments of similar length. It is not an approved medicine in any major jurisdiction, and it is handled as a research chemical.
Thymosin beta-4 itself is a natural peptide of 43 residues found in many cell types and body fluids. Its best-characterised function is binding and sequestering actin monomers, which influences cytoskeletal dynamics. The sequence most often associated with TB-500, LKKTETQ, corresponds to part of that actin-binding region. A different fragment, Ac-SDKP, is also derived from the same parent peptide and is studied in its own right, which is one reason discussions of thymosin fragments can become confusing. The two are structurally distinct and are not interchangeable.
Detection in biological matrices generally relies on liquid chromatography coupled with tandem mass spectrometry, because the peptide lacks a convenient ultraviolet chromophore beyond the amide backbone. Immunoassays have been described, but antibodies raised against the fragment can cross-react with the full-length protein or with unrelated peptides, so findings usually require confirmation by a second technique. Sample preparation typically involves protein precipitation followed by solid-phase extraction. Reported detection windows depend on dose, route, matrix, and instrument sensitivity.
Lyophilised material is stable for extended periods when kept dry and cold, and suppliers typically recommend storage well below freezing. Once dissolved, the peptide is handled at refrigeration temperatures and used within a short period, because peptide bonds and the acetylated terminus can be affected by repeated freeze-thaw cycles, proteases, or extreme pH. Bacteriostatic water and saline are both described as solvents, although preservatives can interfere with some analytical workflows. Reconstituted solutions are inspected for particulates before use.
Dry powder is commonly held at minus twenty degrees Celsius, with some suppliers recommending lower temperatures for long-term archival storage. Once dissolved, solutions are typically kept cold and protected from light, since aqueous peptide solutions can lose integrity through hydrolysis or oxidation over time. Stability data specific to this fragment are limited in the public literature, and much of the guidance comes from general peptide handling practice rather than from controlled degradation studies. Users therefore treat stated shelf lives as approximate rather than fixed.
Identity and purity are normally assessed with reversed-phase high-performance liquid chromatography, paired with mass spectrometry to confirm molecular mass. A certificate of analysis reports a purity percentage, usually derived from chromatographic peak area, but that figure does not by itself prove a correct sequence or the absence of counterions. Independent verification may include amino acid analysis or peptide mapping. Batch-to-batch variation is a documented concern in the research chemical market, and the gap between a quoted purity value and actual peptide content can be substantial when the material is a salt or retains residual water.
Individuals with 3-M syndrome have severe prenatal growth retardation due to growth delays during fetal development resulting in a low birth weight. Growth delays continue after birth throughout childhood and adolescence, ultimately leading to a short stature. Growth delays and immature bone development (growth retardation and delayed bone maturation) typically continue after birth (postnatally), leading to short stature (dwarfism) with proportional development of the arms and legs (as opposed to short stature with abnormally small arms and legs). In most cases, infants with 3M syndrome are unusually small and have a low birth weight despite being carried to term.
It is a member of the small pentraxins family (also known as short pentraxins). The polypeptide encoded by this gene has 224 amino acids. The full-length polypeptide is not present in the body in significant quantities due to signal peptide, which is removed by signal peptidase before translation is completed. The complete protein, composed of five monomers, has a total mass of approximately 120,000 Da. In serum, it assembles into stable pentameric structure with a discoid shape.
Leucine-rich repeat protein SHOC-2 is a protein that in humans is encoded by the SHOC2 gene. This protein was initially identified in Caenorhabditis elegans as SUR-8/SOC2 and was found to be a critical positive regulator of the ERK1/2 signaling pathway that integrates the Ras and RAF components of the ERK1/2 pathway into a multiprotein complex. Specifically, SHOC2 tethers RAS and PP1C proteins and in close proximity to RAF to dephosphorylate “S259” to enable MAPK signaling. The best-studied role of SHOC2 is in modulating signals of the extracellular signal-regulated kinase 1 and 2 (ERK1/2) pathway by forming a holophosphatase complex that activates RAF proteins.
Sources: en.wikipedia.org
Arrestins block GPCR coupling to G proteins in two ways. First, arrestin binding to the cytoplasmic face of the receptor occludes the binding site for heterotrimeric G-protein, preventing its activation (desensitization). Second, arrestin links the receptor to elements of the internalization machinery, clathrin and clathrin adaptor AP2, which promotes receptor internalization via coated pits and subsequent transport to internal compartments, called endosomes. Subsequently, the receptor could be either directed to degradation compartments (lysosomes) or recycled back to the plasma membrane where it can again signal. The strength of arrestin-receptor interaction plays a role in this choice: tighter complexes tend to increase the probability of receptor degradation (Class B), whereas more transient complexes favor recycling (Class A), although this rule is far from absolute. More recently direct interactions between Gi/o family G proteins and Arrestin were discovered downstream of multiple receptors, regardless of canonical G protein coupling. These recent findings introduce a GPCR signaling mechanism distinct from canonical G protein activation and β-arrestin desensitization in which GPCRs cause the formation of Gαi:β-arrestin signaling complexes.
As there are two carbon atoms available for substitution, β-amino acids have four sites (chirality included; as opposed to two in α-amino acids) for attaching the organic residue group. Accordingly, two main types β-amino acids exist differing by which carbon the residue is attached to: ones with the organic residue (R) next to the amine are called β3 and those with position next to the carbonyl group are called β2. A β-peptide can consist of only one kind of these amino acids (β2-peptides and β3-peptides), or have a combination of the two. Furthermore, a β-amino acid can form a ring using both of its sites and also be incorporated into a peptide. β-Amino acids have been prepared by many routes, including some based on the Arndt-Eistert synthesis.
Iron-sulfur protein NUBPL (IND1) also known as nucleotide-binding protein-like (NUBPL), IND1 homolog, Nucleotide-binding protein-like or huInd1 is an iron-sulfur (Fe/S) protein that, in humans, is encoded by the NUBPL gene, located on chromosome 14q12. It has an early role in the assembly of the mitochondrial complex I assembly pathway. NUBPL is located on the q arm of chromosome 14 in position 12 and has 18 exons. The NUBPL gene produces a 5.9 kDa protein composed of 54 amino acids. The structure of the protein includes a presumed iron-sulfur binding (CxxC) signature, a nucleotide-binding domain which has been highly conserved, and a mitochondrial targeting sequence in the N-terminal. NUBPL is required for the assembly of complex I, which is composed of 45 evolutionally conserved core subunits, including both mitochondrial DNA and nuclear encoded subunits. One of its arms is embedded in the inner membrane of the mitochondria, and the other is embedded in the organelle. The two arms are arranged in an L-shaped configuration. The total molecular weight of the complex is 1MDa.
Sources: en.wikipedia.org
Sealed, dry and protected from light at reduced temperature is the usual laboratory convention. Allowing a cold vial to reach room temperature before opening limits condensation. Repeated opening exposes the powder to moisture and should be minimised.
Reported purity reflects the batch tested, the chromatographic method used and whether an independent laboratory performed the work. Values quoted without method detail or a traceable certificate are difficult to compare directly.
Short peptides are rapidly broken down by proteases and appear at low concentrations in urine, so the detection window is narrow. Sensitive extraction combined with tandem mass spectrometry is typically required.
No. Thymosin beta-4 is a 43-residue protein, while TB-500 matches only residues 17 to 23 of that chain. The two are related but differ in size, and a method that identifies one does not automatically identify the other.